Dynomotion

Group: DynoMotion Message: 15217 From: magergar@hotmail.com Date: 12/11/2017
Subject: Limit Switch Pin
I'm trying to configure the limit switchs for the axes, there are a specific pin for that? or how do I configure that?
I have a Kflop with a Kstep, the limit switch goes to the Kflop or the Kstep? I want to configure 3 limits switch one for each axis (X,Y,Z)
Group: DynoMotion Message: 15218 From: TK A2 Date: 12/11/2017
Subject: Re: Limit Switch Pin
Limit switches are handled in software and can make use of any input. To configure them see the Configuration Options under Limit Switch Options:


KStep has 16 24V opto isolated inputs that can be used for limits. See the KStep manual under Opto Isolated Inputs:

HTH
Regards
TK

On Dec 11, 2017, at 12:52 PM, magergar@... [DynoMotion] <DynoMotion@yahoogroups.com> wrote:

 

I'm trying to configure the limit switchs for the axes, there are a specific pin for that? or how do I configure that?
I have a Kflop with a Kstep, the limit switch goes to the Kflop or the Kstep? I want to configure 3 limits switch one for each axis (X,Y,Z)